Solar panel silicone adhesive

Before The Curing

After the curing

Sample: 300mL / tube, 25tubes / box.

1. Features
ZS-GF-D906W is one kinds of the one-component silicone sealant which is room temperature curing. This product is a kind of special sealant for solar modules, which have the properties such as excellent moisture,quake-proof, corona resistance and leakage resistance. It has excellent resistance about cold and hot alternative performance,and the temperature range is -60℃～200℃. And this product is completely operators in the European Union RoHS directive requirements.

2. The Typical Use
Bonding and sealing solar photovoltaic modules of aluminum frame , junction box ,TPT/TPE film ,steel support on the bacd of solar cells,glass ,solar lamps and so on.

3. Instructions
•Surface cleaning: cleaning the sticklied and coated surface,remove the rust,dirt and oil.
•Brush the glue: Unscrew the hose cap (or cut open), pushed the glue to clean the surface, evenly distributed so that will be glued surfaces together and fixed.
•Curing: put the glued or sealed parts in the air and let it be natural cured. It's one curing process that cured from the surface to the internal, in less than 24 hours (at room temperature and 55% relative humidity) glue curing depth of 2 ~ 4mm, if the sizing location more deeper, in particular, which is not easily accessible to the air, then the fully curing time will be extended, if the temperature is low, the curing time will be extended too, sealant is fully cured at least 7 days if the thick have 6mm .

4. Note
After Operating, unused glue must be sealed and stored , and tighten the cap immediately,. if the seal has a little crust when use it in the next time, remove it and it will not affect the normal use. During the storage process, the canal orifices may appear a small amount of the curing phenomenon, cleared it and it can use it again, and no affection to the product performance.

5. Storage And Transportation
•The product must be stored in a cool, dry environment below 25 ℃, can be storaged below 25 ℃ for six months.
•Such products are non-dangerous goods, can be transported as common chemicals. Be careful during transport and prevent the leakage.
•Should be recognized before being used with or without abnormal if the products exceeding retention period.